Table of Contents
Advertisement
Removing the front bezel
Front
bezel
Complete the following steps to remove the front bezel.
Note:
1. Turn off the server and peripheral devices.
2. Disconnect the power cord; then, disconnect all external cables from the server.
3. Remove the three screws from the top of the bezel.
4. Pull the bezel away from the server front.
5. Store the bezel in a safe place.
To replace the front bezel, reverse the previous steps.
Working with adapters
This section provides information about the expansion slots on the system board,
and the peripheral component interconnect-extended (PCI-X) adapters. Your server
comes with two peripheral component interconnect-extended (PCI-X) adapter slots.
PCI-X slot 1 is located on the riser card that is attached to the adapter-support
bracket. PCI-X slot 2 is located on the system board. You must first remove the
adapter-support bracket to access the PCI-X slot 1 connector.
The following illustrations show the location of the PCI-X expansion slots on the
system board and the riser card.
v Read "Safety information" on page 87.
v Read "Handling static-sensitive devices" on page 29.
Chapter 4. Customer replaceable units
35
Advertisement
Table of Contents
