Table of Contents
Advertisement
5. If you have other options to install, do so now; otherwise, go to Completing the
Completing the installation
To complete your installation, you must reinstall the server cover, connect all the
cables, for certain options, run the Configuration/Setup Utility program. Follow the
instructions in this section.
Attention:
turning on the server. Operating the server for extended periods of time (over 30
minutes) with the server cover removed might damage server components.
Installing the cover
Complete the following steps to install the server cover:
1. Install the cover by placing it into position and sliding it forward.
42
xSeries 305 Type 8673: Hardware Maintenance Manual and Troubleshooting Guide
.
DIMM 4
Attention:
To avoid breaking the retaining clips or damaging the DIMM
connectors, open, and close the clips gently.
b. Insert the DIMM into the connector by aligning the DIMM edges with the
slots at each end of the DIMM connector. Firmly press the DIMM straight
down into the connector by applying pressure on both ends of the DIMM
simultaneously. Be sure that the retaining clips snap into the locked position
when the DIMM is firmly seated in the connector.
c. If a gap exists between the DIMM and the retaining clips, the DIMM has not
been properly installed. In this case, open the retaining clips and remove the
DIMM; then, reinsert the DIMM.
Installation.
To maintain proper cooling and airflow, install the server cover before
DIMM 3
Advertisement
Table of Contents
