Table of Contents
Advertisement
Note: See "Server" on page 80 to determine which components should be replaced by a field service technician.
Error code/symptom
00180300 (No more memory above 1MB
for PCI adapter)
00180400 (No more memory below 1MB
for PCI adapter)
00180500 (PCI option ROM checksum
error)
00180600 (PCI device BIST failure)
00180700 (PCI device not responding)
00180800 (Unsupported PCI device
installed)
00181000 (General PCI error)
01295085 (ECC checking hardware test
error)
I9990301 (Fixed boot sector error)
I9990305 (Fixed boot sector error, no
operating system installed)
I9990650 (AC power has been restored)
POST (ISPR) error procedures
Use the ISPR error procedures to help you solve ServeRAID problems. A complete
list of error codes is listed at "ServeRAID error codes" on page 75.
Note: Where the ISPR Error Procedures refer to a Hard disk drive backplane, see
EF10 (Default ISPR)
1. No ISPR error present.
9ZXX thru BZXX (SCSI bus error caused either by cables, termination, defective
drives, etc.)
1. Isolate between SCSI subsystem and controller by disconnecting all hard disk
FRU/action
1. Run the Configuration/Setup Utility program.
2. Failing adapter.
3. System board.
1. Run the Configuration/Setup Utility program.
2. Failing adapter.
3. System board.
1. Failing PCI adapter
2. System board
1. Run the Configuration/Setup Utility program.
2. Adapter.
3. System board.
1. System board
2. PCI adapter
1. PCI adapter
2. System board
1. PCI adapter
2. System board
1. System board
2. Microprocessor
1. Hard disk drive cable
2. Hard disk drive backplane
3. System board
v Install an operating system.
1. Check power connections.
2. AC power cord.
the chapter of this publication that concerns service replaceable units.
drive cables from suspect card, and reboot.
Chapter 6. Symptom-to-FRU index
73
Advertisement
Table of Contents
