IBM 867372X Maintenance And Troubleshooting Manual page 76

Error Code/Symptom
001-XXX-000 (Failed core
tests)
001-XXX-001 (Failed core
tests)
001-250-000 (Failed System
Board ECC)
001-250-001 (Failed System
Board ECC)
005-XXX-000 (Failed Video
test)
011-XXX-000 (Failed COM1
Serial Port test)
011-XXX-001 (Failed COM2
Serial Port test)
014-XXX-000 (Failed Parallel
Port test)
015-XXX-001 (USB interface
not found, board damaged)
015-XXX-015 (Failed USB
External Loopback test)
015-XXX-198 (USB device
connected during USB test)
020-XXX-000 (Failed PCI
Interface test)
030-XXX-000 (Failed Internal
SCSI interface test)
030-XXX-00N (Failed SCSI
test on PCI slot N. Check
system error log before
replacing a FRU.)
035-XXX-099
035-XXX-S99 (Failed RAID
test on PCI slot S. S =
number of failing PCI slot.
Check System Error Log
before replacing a FRU.)
035-XXX-SNN (Check
System Error Log before
replacing a FRU. S = number
of failing PCI slot; NN = SCSI
ID of failing hard disk drive.)
66
xSeries 305 Type 8673: Hardware Maintenance Manual and Troubleshooting Guide
FRU/Action
v System board
v System board
v System board
v System board
1. Video adapter (if installed)
2. System board
v System board
v System board
v System board
v System board
1. Make sure parallel port is not disabled.
2. Re-run USB External Loopback test.
3. System board.
1. Remove USB devices from USB1 and USB2.
2. Re-run test.
3. System board.
v System board
v System board
v Adapter in slot N
1. No adapters were found.
2. If adapter is installed re-check connection.
1. Adapter
2. Hard disk drive backplane
3. Cable
v Hard disk drive with SCSI ID NN on RAID adapter in PCI slot S