Compaq ProLiant 8500 Setup And Installation Manual page 78

4-10 Compaq ProLiant 8500 Servers Setup and Installation Guide
9. Align the new Pentium III Xeon processor with the processor socket.
Install the processor 1, and rotate the ejector levers inward 2 to fully
seat and lock the processor.
2
1
Figure 4-10. Installing the Pentium III Xeon processor
NOTE: If you have installed processors to a total of five or more, you must install Cache
Accelerator modules. See the next section, "Installing the Cache Accelerator."
10. Replace the Processor and Memory module into the chassis.
11. Turn on the server. See Chapter 2, "Server Installation." If the system
does not power up, open the top access, and verify that the system
interlock LEDs are normal. See Table 3-2, "System Interlock Status
Indicators" in Chapter 3, "Server Operation."
12. Verify that the processor was installed correctly. Check the processor
frequency, cache size, and socket location by reviewing the POST
messages on the system console or processor information under the
System Information Menu of the IMD. See Chapter 7, "Integrated
Management Log."
2