Compaq ProLiant 8500 Setup And Installation Manual page 152

Table C-1
Power Cord Set Requirements - By Country
Country
South Africa
Sweden
Switzerland
United Kingdom
United States
Notes:
1. Flexible cord must be <HAR> Type HO5VV-F, 3-conductor, 1.0 mm
Power cord set fittings (appliance coupler and wall plug) must bear the certification
mark of the agency responsible for evaluation in the country where it will be used.
2. Flexible cord must be Type SJT or equivalent, No. 18 AWG, 3-conductor. Wall plug
must be a two-pole grounding type with a NEMA 5-15P (15A, 125V).
3. Appliance coupler, flexible cord, and wall plug must bear a "T" mark and registration
number in accordance with the Japanese Dentori Law. Flexible cord must be Type
VCT or VCTF, 3-conductor, 1.0 mm
grounding type with a Japanese Industrial Standard C8303 (7A, 125V) configuration.
4. Flexible cord must be Type SJT, No. 16 AWG, 3-conductor. Wall plug must be the
3 pin Italian style plug conforming to th4e CEI.23-16-VII standard.
5. Flexible cord must be Type RVV, 3-conductor, 1.0 mm
fittings (appliance coupler and wall plug) must bear the CCEE certification mark.
6. The wall plug must bear a KIATECH mark. Flexible cord must be Type VCT or VCTF,
3-conductor, 1.0mm
conforming to KSC 8305.
7. Flexible cord must be <HAR> Type HO5VV-F, 3-conductor, 1.0 mm
The wall plug must be a two-pole grounding type conforming to BS 546, SABS 164-1
and IS 1293.
continued
Accredited Agency
SABS
SEMKO
SEV
BSI
UL
2
conductor size. Wall plug must be a two-pole
2
conductor size. Wall plug must be a two-pole grounding type
Power Cord Set Requirements C-3
Applicable Note Numbers
7
1
1
1
2
2
conductor size.
2
conductor size. Power cord set
2
conductor size.