Table of Contents
Advertisement
• If you are removing the heat sink and fan assembly for microprocessor 1, disconnect the heat sink
and fan assembly cable from the system fan 2 connector on the system board. See "Locating
1
parts on the system board" on page 15. Then, remove the four screws
that secure the heat
sink and fan assembly.
Note: Carefully remove the four screws from the system board to avoid any possible damage. The
four screws are integrated parts of the heat sink and fan assembly and they cannot be removed
from the heat sink and fan assembly.
Figure 57. Screws that secure the heat sink and fan assembly for microprocessor 1
73
.
Chapter 5
Installing, removing, or replacing hardware
Advertisement
Table of Contents
