Download  Print this page

Lenovo 102912U Installation And User Manual Page 79

Td230 user guide.
Hide thumbs

Advertisement

10. Remove the ribbon cable from the option package. Connect one end of the ribbon cable to the RMM3
connector on the system board. See "Locating parts on the system board" on page 15. Then, connect
the other end of the ribbon cable to the connector on the RMM3.
Figure 54. Connecting the ribbon cable
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to "Completing the parts replacement" on page 90. After installing the
RMM3 and restarting the server, connect a network cable to the RMM3 network interface controller, then
configure the RMM3 by referring to the ThinkServer Remote Management User Guide on the ThinkServer
Documentation DVD that came with your product.
Removing the RMM3
Attention:
Do not open your server or attempt any repair before reading and understanding the Safety Information and the
Warranty and Support Information on the ThinkServer Documentation DVD that came with your product, and
"Guidelines" on page 21. To obtain a copy of the publications, go to:
http://www.lenovo.com/support
This section provides instructions on how to remove the RMM3. If you have installed a RMM3 option in your
server, you can perform the following procedure when you want to remove this option.
.
Chapter 5
Installing, removing, or replacing hardware
67

Advertisement

Table of Contents

   Related Manuals for Lenovo 102912U

Comments to this Manuals

Symbols: 0
Latest comments: