Lenovo 102912U Installation And User Manual page 111

Table 15. Submenus under the Memory RAS and Performance Configuration
Item
Select Memory RAS Configuration
NUMA Optimized
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 16. Submenus under the Mass Storage Controller Configuration
Item
Onboard SATA Controller
SATA Mode
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 17. Submenus under the Serial Port Configuration
Item
Serial A Enable
Address
IRQ
Serial B Enable
Address
IRQ
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 18. Submenus under the USB Configuration
Item
USB Controller
Legacy USB Support
Port 60/64 Emulation
Make USB Devices Non-Bootable
Device Reset Timeout
USB 2.0 Controller
Note: The settings in [ ] are the default settings in the Setup Utility program.
Option
Disabled / [Enabled]
Option
Disabled / [Enabled]
[Enhanced] / Compatibility / AHCI /
SW RAID
Option
Disabled / [Enabled]
[3F8] / 2F8 / 3E8 / 2E8
3 / [4]
Disabled / [Enabled]
3F8 / [2F8] / 3E8 / 2E8
[3] / 4
Option
[Enabled] / Disabled
Disabled / [Enabled] / Auto
[Enabled] / Disabled
[Disabled] / Enabled
10 sec / [20 sec] / 30 sec / 40 sec
[Enabled] / Disabled
Description
Select the RAS configuration for
installed memory modules.
Whether the BIOS contains the ACPI
configuration form required by NUMA
OS.
Description
Enable or disable the integrated SATA
controller.
To select the SATA mode.
Description
Enable or disable the serial port 1 I/O.
Select the serial port 1 I/O address.
Select the serial port 1 I/O interruption.
Enable or disable the serial port 2 I/O.
Select the serial port 2 I/O address.
Select the serial port 2 I/O interruption.
Description
Enable or disable the USB function.
Enable or disable the support on
legacy USB devices.
Enable or disable the I/O port. This
function is for the operating system
that does not support on legacy USB
devices.
Set the USB device as non-bootable
device.
Set the device reset timeout.
Enable or disable the USB 2.0
support.
.
Chapter 6 Configuring the server
99