Introduction Of The Bios Items - Lenovo 102912U Installation And User Manual

1. After the server is connected to a working electrical outlet, the power button becomes active. Turn on
the server by pressing the power button and the POST runs automatically. You will then see the logo
screen. The POST is a set of tests and procedures that are performed each time you turn on your server.
2. Press F2 as soon as you see the logo screen. The Setup Utility program opens. If you have set an
administrator password, you must type the administrator password to access the full Setup Utility
program menu. If you do not type the correct administrator password, a limited Setup Utility program
menu is available.
Note: You can also press Esc as soon as you see the logo screen to review the POST process and
information.
3. The Setup Utility program menu lists various items about the system configuration settings. Select the
settings to view or change.
When working with the Setup Utility program, you must use the keyboard. The keys used to perform various
tasks are displayed at the bottom of each screen.
Notes:
1. Use the default setting for any item you are not familiar with. Do not change the value of unfamiliar items
or items that are not mentioned in this manual to avoid any unexpected problems. If you cannot turn on
the server because of incorrect BIOS settings, refer to "Jumper block settings" on page 17 and use the
jumpers to clear CMOS and recover to the factory default settings.
2. If you have changed any hardware (except the hard disk drives) in the server, you must reflash the BIOS,
the BMC firmware, and the FRU/SDR.

Introduction of the BIOS items

The following tables list all the main menus and items in the Setup Utility program. Some items might vary
because of the BIOS updates.
Notes:
1. Use the default setting for any item you are not familiar with. Do not change the value of unfamiliar items
or items that are not mentioned in this manual to avoid any unexpected problems. If you cannot turn on
the server because of incorrect BIOS settings, refer to "Jumper block settings" on page 17 and use the
jumpers to clear CMOS and recover to the factory default settings.
2. After updating the BIOS, all the BIOS settings become the default settings of the updated BIOS version.
You need to check and reconfigure the BIOS settings for your specific needs.
Table 10. The Setup Utility program main menu
Main
Advanced
Security
Server Management
Boot Options
96
ThinkServer TD230 Installation and User Guide
Item Description
Set the basic BIOS parameters. See Table 11 "Items
under the Main menu" on page 97.
Set the advanced BIOS parameters. See Table 12 "Items
under the Advanced menu" on page 97.
Set the security parameters. See Table 21 "Items under
the Security menu" on page 100.
Set the server system management parameters. See
Table 22 "Items under the Server Management menu"
on page 100.
Set the boot parameters. See Table 23 "Items under the
Boot Options menu" on page 101.