Table of Contents
Advertisement
7. Slide the new optical drive into the drive bay until it snaps into position.
Figure 23. Installing the optical drive
8. Connect one end of the signal cable
available SATA connector (SATA connector 5 recommended) on the system board. See "Locating
parts on the system board" on page 15. Then, locate an available five-wire power connector
connect it to the rear of the new optical drive.
Figure 24. Connecting the optical drive cables
2
to the rear of the new optical drive and the other end to an
Chapter 5
.
Installing, removing, or replacing hardware
1
and
37
Advertisement
Table of Contents
