Starting OmniForm
Starting OmniForm
2-4 Installation and Setup
This section describes how to launch OmniForm.
Before you install OmniForm, please test your scanner to make sure it is
running correctly with your computer system using the manufacturer's
scanning utility or imaging software.
To start OmniForm:
1
Double-click the OmniForm icon in the OmniForm folder on
your hard drive.
Form Assistant appears. It contains six options. Each is a basic
OmniForm procedure.
2
Select an option and click Next>.
Click Cancel to close Form Assistant if you do not want to use
Form Assistant and want to go directly to OmniForm.
See Chapter 5, OmniForm Procedures, for detailed information on the
basic OmniForm procedures.