Juniper SERVICE AVAILABILITY - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 42

JUNOSe 11.1.x Service Availability Configuration Guide
show hardware
show redundancy
20
Monitoring Line Module and SRP Module Redundancy
Use to display information about the hardware installed for redundancy.
See Managing the System in the JUNOSe System Basics Configuration Guide for
details and examples.
See show environment.
Use to display detailed information about the line modules and SRP modules.
See Monitoring Modules in the JUNOSe System Basics Configuration Guide for
details and examples.
See show hardware.
Use to display the configuration for line module redundancy and SRP redundancy.
Field descriptions
SRP
high-availability state State of the high availability mode (disabled,
active, or pending)
current redundancy mode Redundancy mode currently being used by
this router (high-availability or file-system-synchronization)
last activation type Last type of activation that occurred on this router
(that is, the method by which the SRP last booted [cold-start or
warm-start])
Criteria Preventing High Availability from being Active Criteria required
for high availability to be active.
slot Slot in which the line module resides
hardware role Function of the line module: primary or spare
lockout config Status of redundancy on this line module
protected Line module redundancy is enabled
locked out Line module redundancy is disabled
backed up by slot Slot that contains the line module that is a spare for this
primary line module
sparing for slot Slot that contains the primary line module for which this
line module is a spare
revert at Time at which you want the line module to revert
midplane type Identifier for the type of midplane