Monitoring The Configuration Of Icr Partitions - Juniper SERVICE AVAILABILITY - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Table 20: show icr-partition Output Fields (continued)
Related Topics

Monitoring the Configuration of ICR Partitions

Display information about ICR partitions and their status.
Purpose
To display information about all ICR partitions:
Action
host1#show icr-partitions
To display information based on the state of a specific ICR partition:
host1#show icr-partitions Master
To display a summary of the ICR partitions configured:
host1#show icr-partitions summary
Field Name
vrrp-mac
advertise-mac
Configuring the Interface on Which the ICR Partition Resides on page 135
show icr-partition
Interface-Location Vrrp-Id
-----------------------------------------------------------------------
3/5/0.2 20
3/5/0.1 10
2/1/0.1 1
2/5/0.2 2
3/1/0.1 4
-----------------------------------------------------------------------
Total ICR Partitions: 5
Interface-Location Vrrp-Id
-----------------------------------------------------------------------
3/5/0.1 10
-----------------------------------------------------------------------
Total ICR Partitions in Master state: 1
Dormant ICR Partitions: 1
Backup ICR Partitions: 3
Chapter 6: Managing Interchassis Redundancy
Field Description
Configures the interface to use the default MAC
address instead of the VRRP MAC address. Possible
states: enabled or disabled. If the status is enabled,
the interface uses the VRRP MAC address; otherwise,
the interface uses the default MAC address.
Enables the interface to transmit GARP advertisments
when the partition moves from backup state to
master state. Possible states: enabled or disabled. If
the status is enabled, the interface transmits GARP
advertisements; otherwise, the interface does not
transmit GARP advertisements.
State Partition-ID
*Backup part20A
Master part10A
Backup part1Backup
Backup part2Backup
Dormant part4
State Partition-ID
Master part10A
Monitoring the Configuration of ICR Partitions
143