Table 10: Show Redundancy Srp Output Fields - Juniper SERVICE AVAILABILITY - CONFIGURATION GUIDE V 11.1.X Configuration Manual

To display the redundancy status of the SRP modules.
Action
host1#show redundancy srp
high-availability state:
current redundancy mode:
last activation type:
To display the redundancy status of the SRP modules in detail.
host1#show redundancy srp detail
high-availability state:
current redundancy mode:
last activation type:
Criteria Required for High Availability to be Active
----------------------------------------------------
----------------------------------------------------
Active SRP hardware supports High Availability?
High Availability mode configured?
Mirroring Subsystem present?
Mirroring activity levels within limits?
Network Core Dumps disabled?
Running configuration is safe for High Availability?
Standby SRP hardware supports High Availability?
Standby SRP is online and capable of mirroring?
Standby SRP is running the same release?
Table 10 on page 53 lists the show redundancy srp command output fields.
Meaning

Table 10: show redundancy srp Output Fields

Field Name
high-availability state
Chapter 3: Managing Stateful SRP Switchover
active
high-availability
warm-switch
disabled
file-system-synchronization
cold-start
criterion
Field Description
State of high availability mode:
disabled Initial, default state for
high-availability mode. The router continues to
use file system synchronization.
active Data synchronized from the active SRP
module to the standby SRP module during
initialization remains synchronized through
mirroring updates.
pending If an unsupported application is
configured, the router transitions to this state.
initializing If SRP module is in initializing state,
bulk synchronization of memory and NVS
occurs.
Monitoring the Redundancy Status of SRP Modules
met
---
Yes
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
53