Juniper SERVICE AVAILABILITY - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 141

show ip vrrp brief
entries in init state Number of entries in an initialization state
entries in backup state Number of entries in a backup state
entries in master state Number of entries in a master state
entries performing tracking Number of entries performing tracking functions
Example 1
host1#show ip vrrp
Interface: FastEthernet3/0 vrrpVrid: 1
primary address: 12.60.1.1
operational state: init
admin state: disabled
up time: N/A
interval: 1 second
Learning timer mode: disabled
last error status: no error
priority: 100 ( admin priority: 100 )
auth type: none
preemption: enabled
accept data: disabled
assoc address(es): none
track object: xyz
Example 2
host1#show ip vrrp summary
ip interfaces with vrrp: 1
entries: 10
entries enabled: 10
entries with owner priority: 1
entries in init state: 0
entries in backup state: 9
entries in master state: 1
entries performing tracking: 2
See show ip vrrp.
Use to display a brief summary of all configured VRIDs.
Use the interface keyword to specify a specific Fast Ethernet, Gigabit Ethernet,
or 10-Gigabit Ethernet interface.
Field descriptions
Interface Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet interface
specifier
VRID VRRP router instance configured on this interface
Primary Address IP address used while in master state; not necessarily an
associated address
State Operational state of VRRP router: master, backup, or init
Adv Advertisement interval, in seconds
state: Up decrement: 10
Chapter 5: Configuring VRRP
119
Monitoring VRRP