Juniper SERVICE AVAILABILITY - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 142

JUNOSe 11.1.x Service Availability Configuration Guide
show ip vrrp neighbor
120
Monitoring VRRP
Pri Priority assigned to this router
Admin Administrative state of the VRID: enabled or disabled
Example
host1#show ip vrrp brief
Interface
----------------------- ---- --------------- ------ --- --- --------
fastEthernet12/8.1.1
gigabitEthernet12/8.1.1
See show ip vrrp.
Use to display neighbors currently known to the VRRP routers.
A neighbor a router that shares a given VRID with the VRRP router is known
to the VRRP router only when the neighbor becomes a master for an IP address
and sends VRRP advertisements to that effect. If a router sharing the VRID has
not yet become a master, then the local router remains unaware of this neighbor
and this command does not display that neighbor.
Use the interface keyword to specify a specific Fast Ethernet, Gigabit Ethernet,
or 10-Gigabit Ethernet interface.
Field descriptions
Interface Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet interface
specifier and VRID of neighbors known to the VRRP router
time discovered Date and time that the neighbor was detected
primary address Primary IP address of neighbor
adv interval (sec) VRRP advertisement interval in seconds
priority Priority status of VRRP router (255 = owner)
auth type VRRP authentication type: none or text
assoc address(es) IP addresses associated with the VRID that are advertised
by the neighbor
Example
host1#show ip vrrp neighbor
Interface: fastEthernet5/0.0 vrrpVrid: 1
time discovered: 08/09/2001 07:44
primary address: 10.0.0.1
adv interval (sec): 1
priority: 255 (owner)
auth type: none
assoc address(es): 10.0.0.1, 100.0.0.1, 101.0.0.1
Interface: fastEthernet5/0.1 vrrpVrid: 11
time discovered: 08/09/2001 07:44
primary address: 11.0.0.1
VRID Primary Address State
255 123.123.123.123 init
1 1.1.1.1 master
Adv Pri Admin
1 100 disabled
1 254 enabled