Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 Administration Manual page 136

128 M S
ANAGING ENTRIES
Step 6
Update values for the parameters, as necessary:
If you are editing a Security/Policy sentry:
a
Table 7-2 Edit Security/Policy Sentry
Parameter Description
Name Specify a name for this sentry.
Description Specify a description for this sentry. This description appears as
an annotation in the Offense Manager if this sentry results in an
offense being generated.
Minimum number Specify the minimum number of times, in flows, this activity must
of flows before occur before an event generates.
emitting events
Delay between Specify the number of seconds, after the first occurrence of this
emitting events event, before the next occurrence of this event. For example, if
you set the value to 3, an event generates after three seconds of
the first instance of the event.
Maximum emitted Specify the maximum number of times you wish this event to
events per IP generate per IP address. For example, if you set the maximum
alerts to 2, only two alerts generate per event.
Is Enabled Select the check box to enable this sentry. Clear the check box to
disable the sentry.
STRM Administration Guide