Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 Administration Manual page 134

126 M S
ANAGING ENTRIES
Viewing Sentries
Step 1
Step 2
Step 3
Step 4
Sentry - Specifies which network location you wish the sentry to apply. The
•
network location component of the sentry can also specify any restrictions that
you wish to enforce. The variables in the sentry component have priority over
the Package and Logic Unit variables. For example, you can configure a sentry
to monitor the accounting department network location between 8 am and 5
pm. However, you can also specify that you only wish to be notified of any
misuse if the activity continues for more than 10 minutes.
To view the default or deployed sentries:
In the Administration Console, click the System Configuration tab.
The System Configuration panel appears.
Click the Sentries icon.
If this is the first time you have accessed the Sentries window, the Sentry
Initialization window appears. Go to
If this is not the first time you have accessed the Sentries window, go to
Choose one of the following options:
If you wish to include default sentries in your sentry list, click Create Sentries.
a
If you wish to use the default sentries, you must tune these sentries for your
system.
The default sentries that appear depend on the template chosen during the
installation process. For more information on the defaults, see:
- Enterprise Template - See
- University Template - See
- ISP Template - See
If you do not wish to include pre-configured sentries in your list, click Cancel.
b
The Sentries window appears.
From the View By drop-down list box, select the desired view. The options are:
• Objects - View the available sentries or sentry components including:
- Sentry
- Package
- Logical Units
STRM Administration Guide
Step 3.
Appendix B Enterprise Template
Appendix C University Template
Appendix D ISP Template Defaults
Step 4.
Defaults.
Defaults.