Troubleshooting
(continued)
Problems with the image output
Problem
The image changes automatically
Even when you set the video fader
all the way to the bus A or bus B
position, the output image is not
100%.
Effects
Problem
Operating the [CONTROL] fader
does not change the effect
Other
Problem
Menu settings are not saved
Can't change the settings in a
menu
Can't change the BPM
BPM display is blinking
80
(continued)
Cause and Action
●
Could the [BPM SYNC] button be lit?
➔
If the [BPM SYNC] button is lit, the BPM Sync function will switch images automatically. Press
the [BPM SYNC] button to turn off its illumination.
●
In some cases, the output image may not be 100% due to extended use or transportation.
●
Could you have installed the V-4CF crossfader (sold separately)?
➔
Calibrate the video fader.
Cause and Action
●
Have you selected an effect that has an "✽" (asterisk) following the effect name?
➔
The [CONTROL] fader can control effect settings only for an effect that has an "✽" following the
effect name. The EFFECTS button of the effect that can be controlled will blink.
Cause and Action
●
Could you have switched off power before closing a menu?
➔
The settings in a menu are saved in the V-8's internal memory when you close the menu. To
save the settings, edit the values as desired and then close the menu before you switch off the
☞
power.
p. 25
●
Could the [MEMORY] knob be selecting memory number 1?
➔
Select a memory number from 2 through 8.
Memory number 1 contains the factory preset settings. These are read-only, and cannot be
☞
edited.
p. 28
●
Could memory protect be turned "On"?
➔
Turn the "Utility" menu item "Memory Protect" setting "Off."
●
Could you have used the TRANSITION buttons to select the transition effect "003: Fam✽" or
"005: Nam✽"?
➔
Choose a transition effect other than "003: Fam✽" or "005: Nam✽."
If you've selected "003: Fam✽" or "005: Nam ✽," the [BPM/CONTROL] knob will change the
☞
FAM/NAM cross point.
➔
Use the [TAP] button to change the BPM.
☞
p. 77
p. 37
☞
p. 61
☞
p. 42
☞
p. 25