Sending The V-8'S Settings To Another V-8 - Edirol V-8 Owner's Manual

Sending the V-8's Settings to Another V-8

By sending the V-8's parameter settings to another V-8 unit as MIDI data, you can put the settings of both V-8 units in the
same condition.
* Make sure that the transmitting V-8 and the receiving V-8 are set to the same device ID. The device ID is specified by
the "MIDI Setup" menu item "Device ID."
* Set the "MIDI Setup" menu item "MIDI Out/Thru Switch" so that the transmitting V-8's MIDI OUT/THRU connector is
functioning as "Out."
* About the receiving V-8
Settings are overwritten when MIDI data is received, meaning that the previous settings will be lost. If you want to keep
the settings, back them up from the V-8 to an external MIDI device (p. 69).
1
Connect the transmitting V-8's MIDI OUT/THRU connector to the receiving V-8's MIDI IN
connector.
Transmiitting V-8 Rear panel
MIDI OUT/THRU
2
Press the [MENU] button to access the menu, and choose "MIDI Setup."
3
Use the [ ] [ ] buttons to choose "MIDI Bulk Dump," and press the [ENTER] button.
4
Use the [ ] [ ] buttons to choose "Yes [ENTER] Sw," and press the [ENTER] button.
(If you decide to cancel, press the [MENU] button or choose "No" and press the [ENTER] button.)
MIDI data will be sent from the transmitting V-8. When the receiving V-8 receives the MIDI data, its settings will be
overwritten.
5
Press the [MENU] button several times to close the menu.
Using the V-8 with Other Equipment
Receiving
MIDI cable
Press the [MENU] button to access the menu.
Use the [ ] [ ] buttons to select "MIDI Setup."
Press the [ENTER] button to confirm your selection.
(continued)
V-8 Rear panel
MIDI IN
71