Changing The Color Of The Image; Inverting The Image To Form A Negative - Edirol V-8 Owner's Manual

Using Effects
(continued)

Changing the Color of the Image

Inverting the Image to Form a Negative

You can invert the brightness and color of the image to turn it into a negative.
1
Set the [MEMORY] knob to memory number 1.
2
Press a bus A INPUT SELECT button to select an image.
3
Move the video fader to the bus A position to output the bus A image.
4
Press the bus A EFFECTS [2 (NEGATIVE)] button to turn on the Negative effect.
5
Operate the bus A [CONTROL] fader to modify the brightness inversion or color inversion.
6
Press the [2 (NEGATIVE)] button once again to turn off the Negative effect.
The [2 (NEGATIVE)] button will go out.
•
•
48
* The factory preset settings are assigned to memory number 1. For details on
The [2 (NEGATIVE)] button will blink, and the Negative effect will be applied to
the bus A output image.
* The blinking of the [2 (NEGATIVE)] button indicates that you can use the
For each bus, you can use up to four effects simultaneously. However, there are some combinations of effects that cannot
be used simultaneously. For details, refer to "Effects that Cannot Be Used Simultaneously" (p. 107).
You can change the effect that is assigned to the [2 (NEGATIVE)] button. For details, refer to "Assigning Different Effects
to the EFFECTS Buttons" (p. 53).
the [MEMORY] knob, refer to "Storing the Operating Panel Settings" (p. 28).
[CONTROL] fader to modify the brightness inversion or color inversion.