Storing The Operating Panel Settings ([Memory] Knob); Settings Stored At The [Memory] Knob - Edirol V-8 Owner's Manual

Basic Operation
(continued)
Storing the Operating Panel Settings
You can store the settings of the operating panel buttons and faders in memory locations 2–8 of the [MEMORY] knob. To
recall the stored settings, simply choose the desired memory number.
The factory preset settings are assigned to memory number 1. These settings are recall-only, and can't be edited.
* The factory preset settings match the button names printed on the operating panel. For details on the settings, refer to
the section "Settings stored at the [MEMORY] knob," later on this page.
fig.memory-e.eps

Settings Stored at the [MEMORY] Knob

Settings for the following buttons and faders are stored at the [MEMORY] knob. The settings you edit are stored immediately
in the currently selected memory number. The on/off states of the EFFECTS buttons are also remembered.
TRANSITION
buttons
[BPM SYNC] button
Bus A EFFECTS
buttons
Bus B EFFECTS
buttons
Bus A [TRANSFORMER] button
Bus B [TRANSFORMER] button
[OUTPUT FADE] fader
PANEL MODE
28
Operating panel
(memory number 1)
[1 MIX] 001: Mix01
[2 WIPE] 008: Wipe03
[3 EFX] 192: SWipe88
Mode: TransitionA/B
Speed: BPMx1
[1 (FEEDBACK)] 022: FEEDBACK✽
[2 (NEGATIVE)] 033: NEGATIVE✽
[3 (COLORIZE)] 042: COLORIZE✽
[4 (MULTI)] 126: MULTI-HV✽
[1 (FLIP)] 102: FLIP✽
[2 (CHROMA KEY)] 098: CHROMAKEY✽
[3 (LUMINANCE KEY)] 096: B-LUMIKEY✽
[4 (P in P)] 150: PinP✽
02: Trans
02: Trans
02: Manual
01: Video + MidiOut
([MEMORY] Knob)
1
2
Factory preset
Transition effect assigned to each button.
Transition mode and displayed BPM when using BPM
sync (p. 60).
Effect setting assigned to each button.
Settings for operating the [TRANSFORMER] buttons.
Fade operation setting for the [OUTPUT FADE] fader.
Settings for whether MIDI messages will be
transmitted when buttons or faders are operated.
3
4
5
6
7
Stored setting
8
See
page
p. 36
p. 62
p. 53
p. 41
p. 78
p. 67