Adjusting The Input Image For Bus A And B - Edirol V-8 Owner's Manual

Editing the Input/Output Settings

Adjusting the Input Image for Bus A and B

Here's how to adjust the brightness and color of the image that's being input to bus A and bus B.
1
Press the [MENU] button to access the menu, and choose "Utility."
2
Referring to the table below, use the
edit, and press the [ENTER] button.
Menu item
VideoA Bright Adjust
VideoA Color Adjust
VideoA Hue Adjust
VideoB Bright Adjust
VideoB Color Adjust
VideoB Hue Adjust
3
Use the
4
Press the [MENU] button several times to close the menu.
The PC1 and PC2 input images are affected by the individual settings for each PC input (p. 54) in addition to the image
adjustments for bus A and bus B.
If the image is distorted
In some cases, the image may be distorted when synchronization cannot be achieved correctly because the level of
the synchronization signal being output from your video device is lower than the normal level. In such cases, try
adjusting the "Utility" menu item "Video Sync Threshold." This may allow synchronization to be achieved so that the
image will display properly.
56
(continued)
Content
Adjusts the brightness of the image being input to bus A.
Adjusts the color of the image being input to bus A.
Adjusts the hue of the image being input to bus A.
Adjusts the brightness of the image being input to bus B.
Adjusts the color of the image being input to bus B.
Adjusts the hue of the image being input to bus B.
buttons to edit the value.
[ ] [ ]
Press the [MENU] button to access the menu.
Use the [ ] [ ] buttons to select "Utility."
Press the [ENTER] button to confirm your selection.
buttons to select the menu item that you want to
[ ] [ ]