Inverting The Image (Flip) - Edirol V-8 Owner's Manual

Using Effects
(continued)
Inverting the Image
You can invert the image between top/bottom, left/right, or top/bottom/left/right.
1
Set the [MEMORY] knob to memory number 1.
2
Press a bus B INPUT SELECT button to select an image.
3
Move the video fader to the bus B position to output the bus B image.
4
Press the bus B EFFECTS [1 (FLIP)] button to turn the Flip effect on.
5
Operate the bus B [CONTROL] fader to change the direction of the flip.
6
Press the [1 (FLIP)] button once again to turn off the Flip effect.
The [1 (FLIP)] button will go out.
•
•
52
(Flip)
* The factory preset settings are assigned to memory number 1. For details on
The [1 (FLIP)] button will blink, and the bus B output image will be flipped.
* The blinking of the [1 (FLIP)] button indicates that you can use the
For each bus, you can use up to four effects simultaneously. However, there are some combinations of effects that cannot
be used simultaneously. For details, refer to "Effects that Cannot Be Used Simultaneously" (p. 107).
You can change the direction in which the image is flipped, and the effect that is assigned to the [1 (FLIP)] button. For
details, refer to "Assigning Different Effects to the EFFECTS Buttons" (p. 53).
the [MEMORY] knob, refer to "Storing the Operating Panel Settings" (p. 28).
[CONTROL] fader to switch between different directions (three choices) for the
Flip effect.