Edirol V-8 Owner's Manual page 12

Panel Descriptions
(continued)
Operating Panel
fig.top-panel2-e.eps
Bus B INPUT SELECT Buttons
Use these buttons to select the image that will be input to bus B
of the video mixer.
fig.inputsel-indicator-e.eps
The indicator of the selected INPUT SELECT
button will light.
☞ "Switching Between Two Images" (p. 35)
* For channels 5–8, input from the S-video connector will take priority.
* Use the [PC INPUT SELECT] button to choose the input from the PC1/
PC2 connectors.
Bus B EFFECTS Buttons
These buttons turn effects on/off for the bus B image of the video
mixer. If an effect is on, the button will be lit or blinking.
You can use up to four effects simultaneously.
☞ "Using Effects" (p. 42)
* The EFFECTS button will blink if you've selected an effect that can be
controlled by the [CONTROL] fader (
For details, refer to "Effects that can be controlled by the [CONTROL]
faders" (p. 42).
* Depending on the type of effect, there are some combinations that
cannot be used simultaneously. For details, refer to "Effects that Cannot
Be Used Simultaneously" (p. 107).
The settings listed below are the settings for memory number 1
of the [MEMORY] knob. By selecting memory numbers 2–8 you
can assign other effects to the EFFECTS buttons.
[1 (FLIP)] button
[2 (CHROMA KEY)] button
[3 (LUMINANCE KEY)] button
[4 (P in P)] button
☞ "Assigning Different Effects to the EFFECTS Buttons" (p. 53)
12
(continued)
Indicator
).
Flip (102: FLIP✽)
Chroma key (098: CHROMAKEY✽)
Luminance key (096:B-LUMIKEY✽)
Picture in picture (150: PinP✽)
Bus B [CONTROL] Fader
●
You can use this fader to control the settings of an effect
assigned to the blinking EFFECTS button.
☞ "Effects that can be controlled by the [CONTROL] faders" (p. 42)
●
If the [FADE] button ( ) is blinking, this will fade in/out the
bus B image.
The fade color is fixed at black.
☞ "Fading Out the Bus A / Bus B Image" (p. 31)
Bus B [FADE] Button
This button lets you use the bus B [CONTROL] fader to fade the
bus B image.
While the [FADE] button is blinking, operating the [CONTROL]
fader will fade in/out the bus B image.
[FADE] button Fade function
Blinking On
Lit On
Unlit Off
☞ "Fading Out the Bus A / Bus B Image" (p. 31)
Bus B [TRANSFORMER] Button
This button switches between the bus A and bus B images
without using the video fader.
☞ "Using the [TRANSFORMER] Buttons to Switch Images" (p. 40)