Adding Color According To The Brightness Or Darkness Of The Image (Colorize) - Edirol V-8 Owner's Manual

Adding Color According to the Brightness or Darkness of the Image (Colorize)

You can add color according to the brightness or darkness of the image, making the image more colorful.
1
Set the [MEMORY] knob to memory number 1.
2
Press a bus A INPUT SELECT button to select an image.
3
Move the video fader to the bus A position to output the bus A image.
4
Press the bus A EFFECTS [3 (COLORIZE)] button to turn on the Colorize effect.
5
Operate the bus A [CONTROL] fader to change the colorization pattern.
6
Press the [3 (COLORIZE)] button once again to turn off the Colorize effect.
The [3 (COLORIZE)] button will go out.
• For each bus, you can use up to four effects simultaneously. However, there are some combinations of effects that cannot
be used simultaneously. For details, refer to "Effects that Cannot Be Used Simultaneously" (p. 107).
• You can change the effect that is assigned to the [3 (COLORIZE)] button. For details, refer to "Assigning Different Effects
to the EFFECTS Buttons" (p. 53).
* The factory preset settings are assigned to memory number 1. For details on
the [MEMORY] knob, refer to "Storing the Operating Panel Settings" (p. 28).
The [3 (COLORIZE)] button will blink, and the Colorize effect will be applied to
the bus A output image.
* The blinking of the [3 (COLORIZE)] button indicates that you can use the
[CONTROL] fader to change colorization patterns (eight types).
Using Effects
(continued)
49