Switch Type (Swtype); On Controller (On Ctrl); On Value; Off Controller (Off Ctrl) - Kurzweil PC1 - MUSICIANS GUIDE REV B Manual

Switch Type (SwType)

Determines how the switch controller works. If the value of SwType is Momentary, the controller
sends a MIDI Controller message with a programmable value (typically 127 or On) when you
press the switch. The controller sends another programmable value (typically 0 or Off) as soon as
you release it. In other words, a momentary switch is on only as long as you hold it down. When
SW1-SW4, are programmed to be momentary switches, their LEDs light while you're holding the
buttons, then go out when you release them.
If the value of SwType is Toggle, the controller sends a MIDI Controller message with a
programmable value (typically 127 or On) when you depress the controller (turning it on);
depressing the controller again sends another programmable value (typically 0 or Off). When
Buttons SW1-SW4 are programmed to be toggle switches, the LEDs light when you turn them on,
and go out when you turn them off.

On Controller (On Ctrl)

Determines the MIDI Controller message that the controller sends when you turn it on. When
you set a value for this parameter, the PC1 automatically assigns the same value to Off Ctrl.

On Value

Sets the value of the MIDI Controller message sent by the controller when you turn it on. The
value for all zones in the default setup is 127 or On. You can set any value from 0 to 127, but in
most cases, 127 is the most useful. You can also set a value of None, in which case the controller
sends no message. This is useful when you want the controller to do something in one zone but
not in another (although it probably makes more sense to set a value of None for On Ctrl).

Off Controller (Off Ctrl)

Determines the MIDI Controller message that the controller sends when you turn it off.

Off Value

Sets the value of the MIDI Controller message sent by the controller when you turn it off. The
value for all zones in the default setup is 0 or Off. You can set any value from 0 to 127, but in
most cases, 0 is the most useful. You can also set a value of None, in which case the controller
sends no message. This is useful when you want the controller to do something in one zone but
not in another (although it probably makes more sense to set a value of None for On Ctrl).

Entry State

Determines what MIDI Controller message, if any, the controller sends when you select the setup.
If the value is None, the controller sends no message. If the value is On, the controller sends a
message according to its settings for On Ctrl and On Value. If the value is Off, the controller
sends a message according to its settings for Off Ctrl and Off Value.

Exit State

Determines what MIDI Controller message, if any, the controller sends when you leave the setup,
by selecting either a different setup or a different performance mode. If the value is None, the
controller sends no message. If the value is On, the controller sends a message according to its
settings for On Ctrl and On Value. If the value is Off, the controller sends a message according to
its settings for Off Ctrl and Off Value.
Descriptions of Parameters
Setup Editor Parameters
5-15