Chapter 2 Startup; Setup; Installing The Music Rack - Kurzweil PC1 - MUSICIANS GUIDE REV B Manual

Chapter 2
Startup

Setup

When setting up the PC1 for use it must be placed on a sturdy, level surface where both ends of the
unit are supported. A conventional keyboard stand may be used if it is strong enough to support the
unit's weight (about 50 pounds for a PC1X, 23 pounds for a PC161). If you are going to be using the
unit on a table now or in the future, apply the four stick-on rubber feet to the bottom. Figure 2-1
shows the recommended locations marked with pairs of small guide holes. Remove the backing
paper from each rubber foot and attach just forward of each set of guide holes. It is possible that
these locations could interfere with some keyboard stand's supports, so check how the PC1 fits on
your stand before applying the rubber feet.
Installing the Music Rack (only for the PC1X model)
You'll need a Phillips screwdriver to install the optional music rack.
1. Remove the four screws on the rear panel of the PC1, as shown in Figure 2-2.
2. Use the screws to attach the music rack bracket, making sure that the rounded edge of the
bracket is at the top.
3. Slide the music rack in from the top (as shown in the figure).
Figure 2-1 Attaching rubber feet
2-1