Table of Contents
Advertisement
Maintenance and Upgrades
Boot Block
Setting Up For a Software Upgrade
1.
Connect a MIDI cable from the MIDI Out of the computer's MIDI port or interface to the
MIDI In of the PC1.
2.
Launch the sequencer application.
3.
Open the first .MID file using the sequencer program.
4.
Start the boot block on the PC1 using the directions above.
Installing an Operating System or Setups
This procedure is for installing OS and setup files. See Installing a New Boot Block on the previous
page if you want to install a new boot block.
1.
Select
2.
Start playing the MIDI file from the sequencer. While loading, the bottom line of the
PC1's display will show a message
increments with each segment up to Y segments. If the display continues to show
3.
Depending on the size of the file, it may take up to 18 minutes to completely load at
which point the bottom line of the display will show
file to load, open that file from the sequencer and start playing it.
4.
After you have completed loading all of the MIDI files (except a boot block file), press
the Cancel button twice to get back to the main boot block menu, scroll to the
read Resetting the PC1 below, so you can avoid losing any of your PC1 programs or
setups.
5.
Press Yes to execute a hard reset; the PC1 will restart with the new operating system
and/or setups.
Installing a New Boot Block
If the file you are loading is a boot block file with the letter b as the fourth letter in the filename,
follow instructions in Setting Up For a Software Upgrade on page A-4, then continue:
1.
Scroll to
2.
Start playing the MIDI file from the sequencer. While loading, the bottom line of the
PC1's display will show a message
3.
After about a minute, the PC1 will reset and start running normally.
A-4
after starting the sequencer, stop and restart the sequence.
menu item, and select it by pressing Enter. Before doing a hard reset, please
after starting the sequencer, stop and restart the sequence.
by pressing the Enter button.
where X starts at 1 and
. Then, if you have another
and select by pressing Enter.
. If the display continues to show
Advertisement
Table of Contents
Troubleshooting
