Descriptions Of Parameters; In This Chapter; Program Editor Parameters; Controller Value - Kurzweil PC1 - MUSICIANS GUIDE REV B Manual

Chapter 5

Descriptions of Parameters

In This Chapter

This chapter contains a description for each of the PC1's editing parameters. They're organized
into the following sections:

Program Editor Parameters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-1

Setup Editor Parameters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-2
Effects Edit Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-22
MIDI Receive Parameters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-23
Global Parameters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-24
Within each of these sections, the descriptions are organized according to the order in which they
appear in the editing menus. We've included lists of values only where necessary to explain what
those values mean.
For quick reference to all parameters, their possible values, and (where applicable) default
settings, see Parameter Reference on page B-3 (Appendix B).
Program Editor Parameters
There are two primary menus in the Program Editor, represented by pressing the Edit button:
The Timbre menu provides you with Controller Value parameters. Controller Value can set the
specified value when you choose a program.
The Effect menu also acts as an adjunct to the Program Editor, enabling you to replace a
program's effect settings, or save edited effects as part of a new program. See Effects Edit Mode on
page 4-17 for more information about saving effects to programs. Also see page 5-20 for a
description of all Effects Edit Mode parameters.

Controller Value

Sends MIDI Controller messages with the specified value when you select the program. For
example, if you want to hear the full effect of the Mod Wheel on a layer as soon as you start
playing, set the initial value of the Mod Wheel parameter to 127.
Keep in mind that these controller values have an effect only under one or both of the following
conditions:
The program is defined at the factory to use one or more of the MIDI Controllers listed
below to modify the program in some way
The physical controller assignments for the internal setup use one or more of the same
MIDI Controllers to modify all programs in some way
You can set controller values for the following MIDI Controllers:
5-1