Allnotesoff; Device Id; Output Mode; Available Ram (Mem Avail) - Kurzweil PC1 - MUSICIANS GUIDE REV B Manual

Midi performance controller
Table of Contents

Advertisement

Descriptions of Parameters
The Global Menu

AllNotesOff

If you set this to Ignore, the PC1 will ignore the MIDI All Notes Off message. Some instruments
and sequencers (notably older Roland instruments) will send this message when no notes are
being held, even if the sustain pedal is still held. If you are hooked to a Roland sequencer and
find that the PC1 doesn't seem to sustain, set this parameter to Ignore and the problem will go
away.
The default value is Respond, which causes the PC1 to respond to All Notes Off messages.

Device ID

Sets the ID used by the PC1 for MIDI SysEx messages--which the PC1 uses for dumping objects.
The default value is 0.
If you always dump objects--programs, setups, or effects--to the same device and reload them
from that device, you won't have to worry about this parameter; just leave its value at 0 and your
dumps will work just fine. If you plan to dump objects to different instruments in a MIDI chain,
however--or if you want to reload different dumps to different instruments in a MIDI chain--
you'll need to change the device ID for at least one instrument. See More About SysEx Dumps on
page 4-7.

Output Mode

Configures the PC1 for monaural (mono) or stereo audio output. The default is Stereo. You might
want to use mono mode if you have a mono sound system, or have only one channel available on
your mixer.

Available RAM (Mem Avail)

Not editable. Displays the amount of memory (RAM) available for storing user-defined objects.
Approximately 231 kilobytes for units with no user-defined objects.
OS Version
Not editable. Indicates the version of the currently installed operating system software.

Keyboard Version (Ver)

Not editable. Identifies the installed version of the keyboard.

Expansion Block

Not editable. Indicates whether the Expansion Sound Card is properly installed (indicates a
problem if you've installed the card and the value is No).
Internal Sound Version (Ver)
Not editable. Indicates the version of the currently installed internal sounds.
5-30

Advertisement

Table of Contents
loading

Table of Contents