Table of Contents
Advertisement
Programming your PC1
Effects Edit Mode
The top line of the display indicates that we've come from the Program mode—you'd
see "
value of the FX Chg Mode to Panel, the top line shows
where you started).
You can also get to Effects edit mode when you're in MIDI Receive mode, by pressing the Effect
button. In this case the top line of the display shows
press MIDI Recv.
Note: When FX Chg mode is set to Panel, effects are not part of the setup or program. So, if you try to
enter the effect editor from either the program or setup editor when FX Chg mode is set to Panel, there will
be no response to pressing the Enter button in the Effect Menu.
Selecting Different Effects
On page 3-14, we briefly described performance aspects of changing effects. Here we'll go into a
bit more detail about selecting effects.
1.
Enter Effects edit mode as described in the previous subsection.
2.
Find the FXA Select or FXB Select parameter.
3.
Use the Alpha Wheel to change the effect displayed on the bottom line.
This procedure applies to any performance mode, as long as you're using one of the standard
effects in both effect blocks.
You can change the effect associated with the current program or setup as often as you like
without actually affecting the program's or setup's definition. Unless you save your changes, the
original effect gets reapplied to the program or setup as soon as you exit Effects edit mode. See
Saving Effects on page 4-19 to learn how to save the current effect settings to the current program
or setup.
Editing Effects Parameters
Most effects have four parameters that control various aspects of the effect. Our sound engineers
determine which parameters go with which effects; you don't get a choice of parameters, but you
can edit their values any way you want.
1.
Select the effect you want to edit, using the FXA Select or FXB Select parameter.
2.
Press the Left and Right cursor buttons at the same time to get to four FX parameters.
These actually work as a "sub-level parameters" of the FXA Selects or FXB Select
parameter.
3.
Press the Right cursor button one or more times to select one of the four parameters
associated with the current effect.
4.
Change the value of the current parameter.
5.
If you finish changing parameter, press the Left and Right cursor buttons at the same
time again to get back to the FXA Select or FXB Select parameter.
6.
If desired, save your changes, as described below.
4-18
" if you had come from the Setup mode. (If you've changed the
depending on FX Channel and Mode. To get back to MIDI Receive mode,
regardless of
or
Advertisement
Table of Contents
Troubleshooting
