Resetting The Pc1; Running The Diagnostics - Kurzweil PC1 - MUSICIANS GUIDE REV B Manual

Resetting the PC1

If you select
which gives you an important opportunity to think about what you are doing. This
resets all of the PC1's memory back to the initial factory state. This is necessary if you are
upgrading the software. If you're not concerned about losing all of your work, or it has been
saved using a MIDI Sysex dump (see page 4-7), then press the button beneath the Yes on the
display. The PC1 will execute a hard reset and start running normally.

Running the Diagnostics

The
Some diagnostic tests will erase the PC1's memory, which will cause a hard reset when the PC1 is
powered on again. Power off and power on your PC1 to leave diagnostics and return to normal
operation.
by scrolling and pressing Enter, the display will ask
option executes the diagnostics that are loaded with the operating system.
Maintenance and Upgrades
Boot Block
A-5