Fx Wet/Dry Parameter; Fx Bypass Parameter; The Midi Recv Menu; Channel Activation (No Parameter Name Shown) - Kurzweil PC1 - MUSICIANS GUIDE REV B Manual

FX Wet/Dry Parameter

You can adjust the amount of effect using this parameter. There are three Wet/Dry parameters:
A
B
Global A>B

FX Bypass Parameter

Suppose you want to silence the PC1's effects and/or reverb temporarily (without making
permanent changes to the programs or setups you're playing during recording). You can quickly
bypass either or both of the effects blocks globally, by setting the FXA Bypass and FXB Bypass
parameters to On.
Bypassing FX-A or FX-B in any program or zone bypasses the corresponding effect block in all
programs or zones. When you no longer need to bypass effects, go to the FXA Bypass or FXB
Bypass parameter in any program or zone, and set its value to Off. This removes the bypass in all
programs and zones.

The MIDI Recv Menu

The MIDI Recv menu is designed to make it easy to configure your PC1 as a MIDI slave, with a
set of parameters for defining how it responds to incoming MIDI information. Each channel has
an independently-programmable set of the parameters described below. The settings for these
parameters affect the PC1's performance modes, as well as how the PC1 transmits MIDI
information.
You can easily select MIDI channels by holding the MIDI Recv button and pressing the
Program/Setup select buttons. Use the "Category Select" buttons (top row) to select channels 1-8,
and use "Program Select" buttons (bottom row) to select channels 9-16.

Channel Activation (No parameter name shown)

Activates/deactivates current channel.

Program ID and Name (No parameter name shown)

Specifies a program for the current channel. Transmits the program change both to the PC1 and
to the MIDI Out port.

Volume (Vol)

Sets the volume level for the current channel.
Controls how much of FX-A's effect gets applied to the dry signal coming from
the sound engine
Controls how much of FX-B's effect gets applied to the dry signal coming from
the sound engine.
Controls how much of the processed signal coming from FX-A goes to FX-B
and gets FX-B's effect applied to it.
Descriptions of Parameters
The MIDI Recv Menu
5-23