No Sound From Receiving Instrument - Kurzweil PC1 - MUSICIANS GUIDE REV B Manual

No Sound from Receiving Instrument

If you are trying to control another instrument using MIDI and that instrument doesn't respond
to your PC1, check the following:
A working MIDI cable should connect the PC1's Out or Thru/Out jack to the In jack of
the other instrument
If you're using the MIDI Thru/Out port, flip the switch near the MIDI In port to the out
position (a ball-point pen works well for this)
Continuous control pedal 1: check the connection and pedal position
The other instrument should be receiving on the same MIDI channel that the PC1 is
using to transmit MIDI information
All zones that you want to transmit must be active (the lights in the Zone 1-Zone 4
buttons must be green)
The PC1 might be sending MIDI information only to itself: In Setup mode, press the
Edit button and then press Enter button to enter MIDI Xmit menu, then press the right-
arrow button under the display once, then turn the Alpha wheel until you see
Startup
Powering Up
or
2-7