Edit Volume; Edit Effect Type; Edit Effect Levels - Kurzweil KME61 - REV A User Manual

Edit Volume

Use this parameter to set the initial levels of your 3 programs. This allows you to "mix" the
sounds to suit your performance.
Z1:Edit Volume
Vol: 110
This parameter adjusts the relative volumes of the internal sounds played by the zones. 127
is maximum and zero becomes Off. The value may be changed using the + and – buttons
and by the Data slider. It is best to set the loudest zone to a value near 127 then set the
others to lesser values.

Edit Effect Type

In program mode, each program has its own Effect Type and effect levels. In setup mode,
the effects are shared among the 3 programs, but you can still set individual effect levels. So,
for example, if an Effect Type has a Chorus and a Reverb, you can adjust the 1
Chorus and Reverb added to the sound, and the 2
to the sound.
Z*:Edit Effect Type
14 Stage:Chorus
The Effect Type applies to all 3 zones so any of the 3 zone buttons may be pressed to begin
editing. The zone number in the top line changes to an "*" to denote that this page applies
to all of the zones.
The possible values are 30 different effect types (see the appendix for a list).

Edit Effect Levels

As we mentioned above, you can independently set the effects levels for each zone in your
setup. If the Effect Type has 2 names, such as "Stage:Flanger", the first is the A effect, and the
second is the B effect.
Z1:Edit FX Levels
►A: 5%
These parameters independently adjust the wet/dry send levels to each section of the selected
Effect Type. When the Effect Type has only one effect block such as '4 Bright Stage', FX B
level will always be 'NONE'.
B: 10%
nd and 3 rd zones to only have Reverb added
Z1:Edit FX Levels
A: 5% ►B: 10%
Setup Mode
st zone to have
4-5