Stored Effects (Stored Fx); Tuning; Receive Transposition (Recv Trans); Bank-Select Controller (Bank Sel Ctl) - Kurzweil PC1 - MUSICIANS GUIDE REV B Manual

Stored Effects (Stored FX)

The value of this parameter is relevant only for those factory programs and setups to which
you've stored effects settings. For these programs and setups, you can quickly revert to using the
factory effect settings without erasing your user-defined settings (which is what happens when
you use one of the Restore Factory Effects functions in any save dialog). This parameter has two
possible values:
Factory
When you select a program or setup, the PC1 applies the original factory settings to the
corresponding effect, even if you have stored your own effect settings with the program or setup
User
When you select a program or setup, the PC1 applies your user-defined settings (if any) to the
corresponding effect.
If you change the value of this parameter, you'll need to reselect the current program to notice
the change in effect. This parameter works only when the value of FX Chg Mode is Auto. When
FX Chg Mode is Panel, the PC1 uses the factory settings for whatever effect you select from the
front panel.

Tuning

You can tune the PC1 up or down one semitone, in one-cent increments. This can be useful if you
are playing along with a recording, or playing with other acoustic instruments that can't be easily
returned. The default value is 0 cents.

Receive Transposition (Recv Trans)

This allows you to transpose the instrument globally, for all MIDI channels. (Using the Transpose
function in the zone parameters affects only individual zones in a setup, or if changed in
Program mode, affects any program you play on the keyboard, but not any information coming
in the MIDI In port.) The default value is 0 ST.

Bank-Select Controller (Bank Sel Ctl)

Determines how the PC1 responds to bank-select messages received at the MIDI In port. There
are four possible values:
Uses only MIDI Controller 0 as a bank-select command.
0
Uses only MIDI Controller 32 as a bank-select command.
32
Default value. Uses MIDI Controller 0 and 32 as a single combined bank-select
0/32
command, enabling selection of banks numbered from 0 to 16,383.
Responds to either MIDI Controller 0 or 32 as separate bank-select commands.
0or32
Descriptions of Parameters
The Global Menu
5-29