Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2 - ADMINISTRATION GUIDE 02-12-2010 Administration Manual page 430

Configuring Multicast Bundles
With Preboot Services, multicasting is an automated procedure. As described in
Multicasting Example" on page
devices. The multicast session starts when the trigger event that you configured occurs.
Using ZENworks Linux Management, you can install software using a bundle. Software included in
a bundle that is assigned directly is considered mandatory; the software is installed on all assigned
devices (the bundle is directly assigned to the devices, their groups, or their folders).
To configure a Multicast bundle and assign devices to the bundle:
1 In the ZENworks Control Center, click the Bundles tab.
2 Click New > Bundle to start the Create New Bundle Wizard:
3 In the Create New Bundle Wizard, select Preboot bundle, then click Next to display the Select
Preboot Bundle Type page:
430 Novell ZENworks 7.3 Linux Management Administration Guide
350, you simply define a Multicast bundle and assign it to the
"Automatic