Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2 - ADMINISTRATION GUIDE 02-12-2010 Administration Manual page 65

no-verified-certs.Specify the IP addresses of the servers (separated by a comma) for which
you do not want to verify the SSL certificates. The servers are excluded only if require-
verified-certs is True.
proxy-password. Password for the proxy, if any.
proxy-url.The available options are URL, Bypass, or an empty string. By default, it is set
to an empty string, and the device uses the system proxy. Set the value to URL to specify
the URL of the proxy server, or set the value to Bypass for the device to bypass the system
proxy.
NOTE: If you modify the system proxy, you must set proxy-url to use the system proxy
URL if you want the device to use the system proxy. You can set the proxy URL either by
using the command or through the zmd settings in the ZENworks Control Center. For
rug
more information on how to use the rug command, see rug (1). For more information on
how to configure the zmd settings, see Section 7.10, "Configuring the ZENworks
Management Daemon (zmd) Settings," on page 76.
proxy-username. Username for the proxy, if any.
proxy-excludes. Specify the IP address or the DNS name of the server that you want to
exclude from using the proxy settings. You can specify multiple IP addresses or DNS
names by separating the same with a comma. You can use the * wildcard character only in
the IP address. Ensure that there is no space in the specified IP address or the DNS name.
real-time-package-updates. If True, the software inventory is sent immediately to the
server when a package or bundle is changed on the managed device irrespective of the
refresh-interval-software schedule set on the managed device. The default is True. If
False, the software inventory is sent to the server based on the refresh interval specified in
the refresh-interval-software schedule.
refresh-interval. How long between refreshes, in seconds. The default is 7200 seconds.
refresh-interval-hardware. How long between hardware refreshes. The default is 86400
seconds.
refresh-interval-software. How long between software refreshes. The default is 86400
seconds.
refresh-interval-system. How long before system refreshes. The default is 86400 seconds.
remote-enabled. Allow clients to connect to this daemon remotely. The default is True.
remote-port. Port used for connections of remote clients. The default value is 5505.
require-verified-certs. Verify SSL certificates from server. This should remain False
unless your ZENworks Linux Management server has a signed SSL certificate (generated
or purchased). The default is False.
retry-delay. The number of milliseconds to delay before retrying a download. The default
is 2000 milliseconds.
rollback. Store more detailed transaction history, enabling rollback feature. The default is
False.
run-transaction-test. Run a dryrun before attempting to install or remove packages. The
default is True.
security-level. Security requirements to enforce. Possible values are signature, checksum,
and none. The default is Checksum.
service-retry-interval. The default is 300 seconds.
ZENworks Agent 65