Table of Contents
Advertisement
Service
Proxy DHCP Daemon
TFTP Daemon (TFTP Server)
ZENworks Management Daemon
(ZENworks Agent)
ZENworks Imaging Agent
The services reside in the
sections for instructions to help you control the ZENworks services:
Section 5.1.1, "Checking the Status of a ZENworks Service," on page 48
Section 5.1.2, "Starting a ZENworks Service," on page 48
Section 5.1.3, "Stopping a ZENworks Service," on page 49
Section 5.1.4, "Restarting a ZENworks Service," on page 49
5.1.1 Checking the Status of a ZENworks Service
To check the current status of a service, use the following command:
/etc/init.d/servicename status
Replace servicename with the name of the service as listed in
To check the current status of all services, use the following command:
/opt/novell/zenworks/bin/zlm-config --status
5.1.2 Starting a ZENworks Service
To start a service, use the following command:
/etc/init.d/servicename start
Replace servicename with the name of the service as listed in
To start all services, use the following command:
48
Novell ZENworks 7.3 Linux Management Administration Guide
Service Name
novell-proxydhcp
novell-tftp
novell-zmd
novell-zislnx
directory on the ZENworks Server. Refer to the following
/etc/init.d
Description
Used with a standard DHCP server to
inform PXE-enabled devices of the IP
address of the Novell TFTP server. It
also responds to PXE devices to indicate
which bootstrap program (
nvlnbp.sys
to use.
Used by PXE-enabled devices to
request files that are needed to perform
imaging tasks. It also provides a central
repository for these imaging files, such
as the Linux kernel and initrd. A PXE-
enabled device uses this server to
download the bootstrap program
(
nvlnbp.sys
).
Used to enable the server as a managed
device.
Used to save and restore image-safe
data on the server (as a managed
device). Only runs when launched by the
ZENworks Agent.
Table 5-1 on page
47.
Table 5-1 on page
47.
)
Advertisement
Table of Contents
Need help?
Do you have a question about the ZENWORKS LINUX MANAGEMENT 7.3 IR2 - ADMINISTRATION GUIDE 02-12-2010 and is the answer not in the manual?
Questions and answers