Table of Contents
Advertisement
6 In the Remote Execute Policy page, configure the following settings:
Executable Type: Select Binary.
Maximum waiting time: Select Wait till the program completes the execution.
Executable file name:
Executable file parameters:
7 Click Next to display the Summary page.
8 Review the information.
9 Click Next to display the Policy Assignment page, then assign the policy to SLES 9 and SLES
10 devices
10 Click Next to display the Policy Schedule page, then select the schedule to apply to the
assignments.
11 Click Next to display the Policy Groups page. For more information, see
Section 16.6, "Remote Execute Policy," on page
12 Click Next to display the Finish page.
13 Click Finish.
After the policy is applied on the managed devices, a copy of
directory.
7.2 Configuring the Device Refresh Schedule
The Device Refresh Schedule page determines how often devices contact a ZENworks Server to
update policies, settings, and inventory scanning. By default, each refresh schedule occurs every two
hours.
These settings apply to all devices in your ZENworks Management Zone unless it is changed on a
device folder or individual device. To change refresh schedules for an individual device, click the
Devices tab, locate and click the device's name, click the Settings tab, click Device Refresh
Schedule, then click Override Settings. Click the
The refresh interval is not reset until the device refresh is complete. For example, assume you set a
refresh interval of 2 hours. The device's first refresh occurs at 6:00 p.m. and takes 13 seconds to
complete. The second refresh will occur at 8:00:13 p.m. (2 hours after the refresh was completed at
6:00:13). If the second refresh takes 15 seconds to complete, the third refresh will occur at 10:00:28
p.m.
To configure the device refresh schedule for all devices in your ZENworks system:
1 In the ZENworks Control Center, click the Configuration tab.
2 Click Device Refresh Schedule.
3 Specify the Days, Hours, and Minutes between device refreshes in your ZENworks system.
4 Click OK.
7.3 Configuring Device Inventory Settings
The Device Inventory page determines the Inventory Roll-up settings.
72
Novell ZENworks 7.3 Linux Management Administration Guide
.
/bin/cp
${source_path}/deviceid /tmp
164.
icon for additional help.
.
Step 12
in
is created in the
deviceid
/tmp
Advertisement
Table of Contents
