Your vehicle may be equipped with
an anti-intrusion alarm.
• Exterior perimeter protection by
means of detectors on the access
points (doors, tailgate, bonnet) as
well as on the electrical supply.
by means of ultrasonic sensors
(detecting movement inside the
This can be deactivated using
The installation also includes a siren
and a warning lamp 2 visible from
the outside, indicating the three
possible alarm statuses:
• Alarm not armed (not on standby),
warning lamp off.
• Alarm armed (on standby), the
warning lamp flashes slowly.
intrusion), the warning lamp flashes
rapidly if the alarm is disarmed
with a press on button B. It stops
flashing as soon as you switch on
Note: in the event of a malfunction,
the warning lamp 2 comes on con-
A C C E S S
Arming the alarm using the
Switch off the ignition and leave the
Ensure that all doors and the boot
Lock the vehicle using button A on
the remote control.
When the alarm is armed, the
protections become active within
45 seconds (volumetric).
for 30 seconds, accompanied by
The alarm then reverts to armed
status, but the deployment remains
memorised and is signalled by the
rapid flashing of the alarm warning
lamp 2 when you press the unlocking
button B. The flashing stops when
you switch on the ignition.
The siren is also triggered if there is
a cutting of the electrical supply. To
stop it, restore the electrical supply
then give a press on the unlocking