1Scrsvr; 2Sound - Fluke MOLBOX RFM Operation And Maintenance Manual

OPERATION
To access the PREFS menu press [SPECIAL],
and select <5prefs>. The display is:
See Sections 3.6.5.1 to 3.6.5.4 for detailed information on each PREFS function.
3.6.5.1 <1SCRSVR>
PURPOSE
To adjust the time setting of molbox RFM's SCREEN SAVER function.
PRINCIPLE
molbox RFM has a SCREEN SAVER function which causes the display to dim
after a front panel key is NOT pressed for a certain amount of time. The default
time activates the screen saver after 10 minutes. The time can be adjusted by
the user or screen saving can be completely eliminated.
OPERATION
To access the SCREEN SAVER function, press [SPECIAL] and select
<5prefs>, <1ScrSav>. Edit the time, in minutes, after which the screen saver
will activate to dim the screen. Set zero to eliminate the SCREEN SAVER
function.
Setting screen saver time to zero eliminates the SCREEN SAVER function so
that the display remains permanently at full brightness. The display may also
be completed suppressed using the SOFT [ON/OFF] key (see Section 3.3.3).
3.6.5.2 <2SOUND>
PURPOSE
To adjust or suppress the molbox RFM keypad valid and invalid key
press sounds.
PRINCIPLE
molbox RFM provides audible feedback by a brief "beep" when a valid key press
is made. Invalid key presses are indicated by a descending two tone "blurp".
The frequency of this valid key press beep may be selected from three choices
or all keypress sounds may be suppressed.
OPERATION
To access the key press SOUND function, press [SPECIAL] and select <5prefs>,
<2sound>.
Select <1none> to suppress the valid and invalid key press sounds completely.
Select between <2lo>, <3mid> or <4hi> to adjust the valid key press
tone frequency.
The SOUND function only affects the valid key press tone.
1ScrSvr 2sound 3time
4ID
Page 85 © 1998-2007 DH Instruments, a Fluke Company
3. OPERATION