Command Summary; Table 21. Command Summary - Fluke MOLBOX RFM Operation And Maintenance Manual

molbox™ RFM™ OPERATION AND MAINTENANCE MANUAL
4.3.2

COMMAND SUMMARY

SYNTAX
*CLS
*ESE(?)
*ESR?
*IDN?
*OPC(?)
*OPT?
*RST
*SRE(?)
*STB?
*TST?
#
ABORT
AIRW(=)
ALLR
BEEPER(=)
BPR(=)
COMn(=)
DATE(=)
DEVICE=EXT
DP
ERR
FA=
FCOEF
FR
FRA
FUNIT(=)
GAS(=)
ID (=)
KFACT(=)
LEAKCK(=)
LOCAL
MEM
MICRORNG(=)
MOLBLOC
OHMS
PCAL
PCALDATE(=)
PCOEF
© 1998-2007 DH Instruments, a Fluke Company

Table 21. Command Summary

Clears the status registers and all queues.
Read or set the Event Status Enable register.
Read the Event Status Register.
Identify the product and software version.
Read or set the Operation Complete register (not applicable to the RFM).
Read the molbox RFM options installed.
Reset user settings to factory defaults.
Read or set the Service Request Register.
Read the Status Byte.
Read the system self-test results.
Send a command string out of the molbox RFM COM2 port.
Stop an active averaging, tare, leak check or purge cycle.
Read or set the humidity ratio of the gas, AIR.
Read the next measurement of molbloc flow, the RFM up and downstream RPT pressure
values, the molbloc temperature, and the optional microrange RPT pressure.
To actuate the internal beeper for half of a second.
Read or set the back pressure ratio mode when using molbloc-S.
Read or set the configuration of the COM1 or COM2 port.
Read or set the internal time and date.
Loads information on molbloc connected to molbox RFM into molbox RFM.
Read the differential pressure value being used to calculate flow.
Read the last error message.
Start a single flow averaging cycle.
Read the coefficient to convert kg/s to the current flow units.
Read the next flow measurement.
Read the results of a completed flow averaging cycle.
Read or set the flow display unit.
Read or set the gas type being used.
Read or set the molbox RFM ID.
Read or set the "K" factor.
Start a molbox RFM or system leak check cycle or check if a cycle is complete.
Enable the front panel controls if in remote and go to local.
Read the memory test status.
Read or set the optional microrange operation mode.
Read the active molbloc header data. Does not load molbloc information.
Read the resistance measurement of the molbloc's PRTs.
Read or set the user RPT calibrations.
Read or set the user RPT calibration dates.
Read the coefficient to convert Pascal to the current pressure units.
Page 98
PURPOSE