Table of Contents
Advertisement
7.2
WARRANTY STATEMENT
Except to the extent limited or otherwise provided herein, DH Instruments, a Fluke Company (DHI)
warrants for one year from purchase, each new product sold by it or one of its authorized distributors,
only against defects in workmanship and/or materials under normal service and use. Products which
have been changed or altered in any manner from their original design, or which are improperly or
defectively installed, serviced or used are not covered by this warranty.
DHI and any of its Authorized Service Providers' obligations with respect to this warranty are limited to
the repair or replacement of defective products after their inspection and verification of such defects. All
products to be considered for repair or replacement are to be returned to DHI, or its Authorized Service
Provider, freight prepaid, after receiving authorization from DHI or its Authorized Service Provider. The
buyer assumes all liability vis-à-vis third parties in respect of its acts or omissions involving use of the
products. In no event shall DHI be liable to purchaser for any unforeseeable or indirect damage, it being
expressly stated that, for the purpose of this warranty, such indirect damage includes, but is not limited to,
loss of production, profits, revenue, or goodwill, even if DHI has been advised of the possibility thereof,
and regardless of whether such products are used individually or as components in other products.
Items returned to DHI under warranty claim but determined to not have a defect covered under warranty
or to not have a defect at all are subject to an evaluation and shipping charge as well as applicable repair
and/or calibration costs.
The provisions of this warranty and limitation may not be modified in any respect except in writing signed
by a duly authorized officer of DHI.
The above warranty and the obligations and liability of DHI and its Authorized Service Providers exclude
any other warranties or liabilities of any kind.
COMPANY
DH Instruments, a Fluke
Company
Minerva Meettechniek B.V.
Ohte Giken, Inc.
Technology Center
DH Products Technical
Service Division
Table 34. Authorized Service Providers
DH INSTRUMENTS, A FLUKE COMPANY
AUTHORIZED SERVICE PROVIDERS
ADDRESS
4765 East Beautiful Lane
Phoenix AZ 85044-5318
USA
Chrysantstraat 1
3812 WX Amersfoort
the NETHERLANDS
258-1, Nakadai,
Kasumigaura-machi, Niihari-
Gun
Ibaraki, 300-0133
JAPAN
National Institute of Metrology
Heat Division
Pressure & Vacuum Lab
NO. 18, Bei San Huan Donglu
Beijing 100013
PR CHINA
Page 159
TELEPHONE,
FAX & EMAIL
Tel 602.431.9100
Fax 602.431.9559
cal.repair@dhinstruments.com
Tel (+31) 33.46.22.000
Fax (+31) 33.46.22.218
info@minervaipm.com
Tel 81.29.840.9111
Fax 81.29.840.9100
tech@ohtegiken.co.jp
Tel 010.64291994 ext 5
Tel 010.64218637 ext 5
Fax 010.64218703
cxcen@mx.cei.gov.cn
© 1998-2007 DH Instruments, a Fluke Company
7. APPENDIX
NORMAL SUPPORT
REGION
Worldwide
European Union
Japan/Asia
Peoples Republic of
China
Advertisement
Table of Contents
