Setting The Device Base - AMX COLOR TOUCH PANELS WITH AUDIO (G3 FIRMWARE) Instruction Manual

FIG. 26 Setup page
3. Enter
page. If you press ENTER after typing an incorrect password, you are immediately returned to
the previous page.
4. Press
Setup page when enabled, as shown in FIG. 27.
FIG. 27 Protected Setup page with the active EDITOR button
5. Press
6. Press
indicating Edit mode is active.
7. Press
used to design and modify button and page settings.

Setting the Device Base

Press the
device address to the touch panel.
1. Enter the base address for the touch panel. The base address range is from 1 - 255. Standard
device addresses begin at 128.
2. Press
4" Color Touch Panels with Audio
(default password) in the keypad and press
1988
to enable the Edit mode. The
EDITOR
to close the Protected Setup page and return to the Setup page (now in Edit mode).
EXIT
again to return to the Main page. The
EXIT
to open the Edit bar. The
EDIT
option, in the Protected Setup page (FIG. 27), to assign a base (starting)
DEVICE BASE
to save.
ENTER
to open the Protected Setup
ENTER
button is highlighted in the Protected
EDITOR
button appears at the top of the page
EDIT
and options, in the Edit bar (FIG. 28), are
BUTTON PAGE
Designing Touch Panel Pages
29