AMX COLOR TOUCH PANELS WITH AUDIO (G3 FIRMWARE) Instruction Manual page 39

4" Color Touch Panels with Audio
adjustment to the PIR activation threshold is also achieved through the use of the IRSL
AXlink Send_Command. Refer to page 47 for more information.
Setting the value to zero forces the value to 1. Disabling of the PIR is done by disabling
both the Infrared Push/Release and the Infrared Wake features. Refer to the
and
PUSH/RELEASE WAKE
displays the activity of the infrared sensor. This button toggles
INFRARED STATUS
between the available On/Off states; depending on whether there is an activation of the
sensor. When an object crosses the activation range of the sensor, the button turns to the
On state.
enables an Input/Output change that is sent to the AXlink program.
INFRARED PUSH
This feature is independent of the other infrared features such as
can be disabled by entering an
the IRPU AXlink Send_Command. Refer to page 47 for more information. Sample uses
of this feature include the illumination control of room lights. The following occurs when
this feature is active:
On the initial detection of a user within the range of the PIR, an I/O change of TRUE
(Push) is sent to the AXlink program.
If the presence of a user has been detected and the PIR no longer senses the presence
of a user for a period of thirty (30) seconds; an I/O change of FALSE (Release) is
sent to the AXlink program.
The PIR I/O change is always disabled when in the Adjust Sensors Mode.
turns On the backlight of the display when the PIR detects the
INFRARED WAKE
presence of a user. This feature is disabled through the use of the IRWA AXlink
Send_Command. Refer to page 47for more information.
DIM MODE BRIGHTNESS
Dim-Room (DRM) mode operation. The Dim-Room brightness level range is 1 - 8. An
adjustment to the Dim-Room brightness level is also achieved through the use of the
BRDM AXlink Send_Command. Refer to page 45 for more information.
AUDIO AND IR DEVICE SETUP
control, and the IR device codes. Refer to the Using the Adjust Sensors Setup
Page section on page 34 for more information.
sets the Light Sensor to automatically switch the touch panel display
LIGHT DIM MODE
backlight between a Normal-Room (NRM) or Dim-Room (DRM) setting (active when
the button is pressed). This feature is disabled through the use of the
LIGHT DIM MODE
LSDM AXlink Send_Command. Refer to page 48 and the LS Level # definition below
for more information.
In the Normal-Room mode, the brightness of the panel is the same as the value set in
the Setup > Set Brightness page.
In the Dim-Room mode, the brightness of the backlight is user selectable through the
DIM MODE BRIGHTNESS
button descriptions for more information.
value of zero or through the use of
INFRARED CHANNEL
adjusts the brightness of the touch panel backlight for the
provides the speaker volume control, microphone
level setting on the Adjust Sensors page.
Designing Touch Panel Pages
INFRARED
. This
INFRARED WAKE
35