AMX COLOR TOUCH PANELS WITH AUDIO (G3 FIRMWARE) Instruction Manual page 13

Install the (4) #4-40
machine screws into
into the places
A - Faceplate
(bezel)
FIG. 5 Wall Mount panel installation configuration for pre-existing conduit/wall box in a pre-wall construction
Don't disconnect the connectors from the touch panel. The unit must be installed with
the necessary connectors before being inserted into the drywall. Verify that the panel
is receiving power and functioning properly to prevent repetition of the installation.
8. Fasten the CB-CP4/A to the stud through the tabs shown in FIG. 5. The wallbox can be secured
to the stud by using either nails or screws. This installation must be done prior to any wall
installation.
9. Carefully slide the main unit (B in FIG. 5) into the conduit/wallbox (C in FIG. 5) until it slides
in completely and flush against the wallbox.
10. Use the four (4) securing screws (#4-40 screws) to attach the main AXD unit to the conduit
wallbox. Refer to B in FIG. 5 on page 9 for more information.
11. Use a grounded Phillips screwdriver to tighten the screws in a clockwise direction
12. Fasten the main AXD unit to the surface using the four (4) surface screws (not provided with
unit) until the housing is securely fastened and flush against the wall.
13. Carefully remove any of the blank pre-installed plastic pushbuttons by pushing the top rim of
the button towards the LCD panel and applying a small amount of force.
14. Carefully insert the six (6) desired replacement pushbuttons (up to 12 other pre-labeled buttons
come in the accessory button kit) by grabbing the button at either sides, inserting the
attachment pegs into their respective connector holes, and pressing down firmly (FIG. 6 on
page 10).
4" Color Touch Panels with Audio
Stud beam
Attachment site for beam
indicated
C - Optional CB-CP4/A
conduit/wallbox
SURFACE
B - Main AXD unit consists of
the touch panel and backbox housing
Installation
9