AMX COLOR TOUCH PANELS WITH AUDIO (G3 FIRMWARE) Instruction Manual page 49

System Send_Commands (Cont.)
BEEP n s
Gives an output of
one beep.
BRDM
Adjusts the Dim-
Room Brightness
setting.
BRIT
Adjusts brightness
of display.
CALIBRATE
Starts the touch
panel calibration
sequence.
4" Color Touch Panels with Audio
The Beep button in the Protected Setup page must be set from 1 - 5 for the BEEP
command. The <n> and <s> are optional such that BEEP by itself enables a standard tone
and duration.
Syntax:
"'BEEP,<n>,<s>'"
Variables:
n = tone value (0 = minimum; 5 = maximum).
s = duration of beep in whole number seconds (0 = minimum; 255 = maximum).
Sounds tone number n for x seconds.
Examples:
SEND_COMMAND TP,"'BEEP,1,3'"
Sound tone one for three seconds
SEND_COMMAND TP,"'BEEP,2,63'"
Activates tone number two for 63 seconds. A value of zero for the duration is used to turn
a tone Off. "BEEP,2,0" deactivates tone two that was activated in the previous example.
The BEEP command will disable the beep after a QBEEP command.
The brightness level set with this command corresponds to the value present on the Dim
Mode Brightness level indicator on the Adjust Sensors page.
Syntax:
"'BRDM,<n>'"
Variable:
n = brightness level (1 = minimum; 8 = maximum)
Example:
SEND_COMMAND TP,"'BRDM,4'"
Adjusts the Dim-Room brightness level to four.
Syntax:
"'BRIT-<level>'"
Variable:
level = 1 - 8 (1 = minimum; 8 = maximum)
Example:
SEND_COMMAND TP,"'BRIT-8'"
Sets to highest brightness level.
Syntax:
"'CALIBRATE'"
Example:
SEND_COMMAND TP,"'CALIBRATE'"
Starts the calibration operation on the touch panel.
Programming
45